Hello everyone,

I'm working on LN 6.1 FP3.

Something strange happens to me, because I have a table with three fields, the first two being the main index table, but in a certain company in the same VRC allows me to enter duplicate values (incorrect) and in the other companies it respects the constraint of index (correct).

Does anyone can tell me whats going on?

Thank's

Have you checked to make sure that duplicates allowed was not checked on that table in that company?

Have you checked to make sure that duplicates allowed was not checked on that table in that company?

Hi,

Thank you, please can you explain me how to do it?

Hi

U can check Indices of table in table definition.

In session ttadv4520m100, go to second satelite session(second tab) check if duplicate checkbox is checked or not. If it is checked then duplicate values allowed for that index, other wise not.

Also note that you are allowed to check duplicate only if it is not first(primary) index.

Regards,
MilindV

Hi

U can check Indices of table in table definition.

In session ttadv4520m100, go to second satelite session(second tab) check if duplicate checkbox is checked or not. If it is checked then duplicate values allowed for that index, other wise not.

Also note that you are allowed to check duplicate only if it is not first(primary) index.

Regards,
MilindV

Hi,

Thank you, I know all you told me, but my question is because Mark explained me configuration by company.

Mark, Do I understand fine?

Yes - the answer is the same. If this company shares VRC with other companies then the issue maybe something different. Without understanding your setup it is hard to say. My assumption was each company had its own VRC.

Yes - the answer is the same. If this company shares VRC with other companies then the issue maybe something different. Without understanding your setup it is hard to say. My assumption was each company had its own VRC.

No, all companies own the same VRC, but only in one company occurs this.

If that is the case then the same configuration should be in play for the companies. My best guess is something is corrupt in that one company. In baan iv I would have the admin first for a create rdd on the table, then re-organize the table repairing reference counts. Not sure about baan 5.

If that is the case then the same configuration should be in play for the companies. My best guess is something is corrupt in that one company. In baan iv I would have the admin first for a create rdd on the table, then re-organize the table repairing reference counts. Not sure about baan 5.

Hello Mark,

gget97 has the problem in LN.


Hello everyone,

I'm working on LN 6.1 FP3.

Is it a multisite installation ?

Regards

Hello Mark,

gget97 has the problem in LN.



Missed that in the first post. I would have thought some of the basics would still be the same.