hi,
is it possible to open any session with default filter?
if yes then pls tell me the process.

Regards,
nirali

In the Filters (ttadv9593m000) session, use specific -> 'Set as Default'

In the Filters (ttadv9593m000) session, use specific -> 'Set as Default'

Hi. I have tried to find this session or something similar in LN FP2 but it says it is not a main session. I just can't seem to find where it triggers from so i can set my filter and give it a go ...

Anyone point me in right direction pls ?

thx in advance.
:confused:

OK, I see where it is, same place i normally see the filters. I just wasn't sure if I could force the filter on everyone who tries to run that session. I make a number of filter public but how to set them for all users without them thinking about it.

table ttadv993000 in GTM shows the filters and a 'set as default' enum to select.

Hello together,

does anyone know how it works i FP9?
There's no data definition for the table ttaad993000. I'm a Supervisor and if I set a filter as default it only takes effect for me, not for other users.

regards
Rainer

It was actually ttadv993000 that shows the filters.

But, following NPRao, open your session up, make sure the filter you have active is the one you want, or add a new one. When in the edit mode of setting up the filter, click on "Specific" again and there are options there. This is where you set the session default. I missed this the first couple times through .... see if that works for you.

hello metropoj,

unfortunately not. It only works for my own user, not for others.

maybe there'is a authorization problem.

I'll use the following workaround: copying the filter from user "*" to a specific other user in table ttadv993000 by gtm.

many thanks for your help.

One last thing to check is when you are in your edited filter mode, there is a box that should show called "Publish Filter" Turn this on if it is off and see if that helps at all.