s_amrutkar7
29th September 2008, 08:02
I am working on LNFP2. I have one Scenario of workshop as per following:
Workshop department manufactures new mould assembly by using mould box,setting plates,Liners & Dies according to requirements. Mould is prepared according to production schedule & transferred to press department on requisition. As mould life expires it is send back to the workshop for rework where mould is disassembled & rework is done on liners i.e. regrind with the help of surface grinder. Same thing is happening for Dies also then mould is again assembled & sent to the production department.
Note: Mould box, die block -- purchased
Liners,Dies,Setting plates -- Manufactured
Can Anyone Suggest As is mapping for this scenario in lnfp2.
Workshop department manufactures new mould assembly by using mould box,setting plates,Liners & Dies according to requirements. Mould is prepared according to production schedule & transferred to press department on requisition. As mould life expires it is send back to the workshop for rework where mould is disassembled & rework is done on liners i.e. regrind with the help of surface grinder. Same thing is happening for Dies also then mould is again assembled & sent to the production department.
Note: Mould box, die block -- purchased
Liners,Dies,Setting plates -- Manufactured
Can Anyone Suggest As is mapping for this scenario in lnfp2.