Hello,

I use BAAN VI and there is a production orders that I cannot close. The order status is Completed. When I try to close the order a report is printed which says there is some quantity to be backflushed. I run backflush but it is not a solution.

Any suggestions?
Thanks...

for the material which is used in this production order the on hand quantity is less than allocated quantitiy. is this the reason why system cannot backflush the material????

Hello,
Yes, you need to have enough material on stock to be able to backflush. I e qty on hand should be larger than allocated qty.

How can I close the production order that have the status Completed. I looked at warehouse orders of it but everything is normal. Any way to close it?

Note: My company do not use QM.

Hi,

When you are trying to close the production order what message you are receiving?

regards,
Roy

The production order is finished. So I want to close the order on system. Backflush is done. Briefly everything is done to close the order. The error message is "there is still quantities to backflush". I run backflush many times but I could not close it.

Note: I ran tisfc0120s000 session and active status returned to completed. then I must run ticst0201m000 session to close the order. When I run the second session I receive the error message

Hi,

If the message says "till quantities required to backflush" then please check the estimated item's inventory level, may be the materials do not have enough stock on hand to backflush.

regards,
Roy

There is no material that is not backflushed. The problem is the quantity of "Quantity to backflush" does not pass to "Quantity Backflushed" at tisfc0110m000 session at Quantity tab. Is there any solution to this problem?

Hi,

Can you please resend the document in word format, I am not able to open it.

regards,
Roy

Here is the picture.

I solved the problem. It was because the Route of the PO is not defined for the manufactured item at tirou1101m000

Thanks for letting us know.

regards,
Roy