Hi,

I'm trying to generate ASN for deliveries, but always get the same message when I run whinh4230m100 (confirm outbound ASN) "No data within selection".

The purpose is to get the ASN001 (EDI message).

Any idea?. Thanks in AV

Hi,

is session whinh4230m100 linked to the ASN001 message in edi session "Outgoing Messages by Session"?

Regards,
Juergen

yes. it is, and whinh4275m000 and whinh4475m000 too.

But it doesnt works any of them.

Hi,

are you sure that your general EDI setup is correct?

Check Sessions:
- Supported EDI Messages (Field "Active" is set to "yes" for ASN001)
- EDI Messages Supported by Business Partner
- Networks
- Business Partner EDI Data by Network
- Conversion of Sales Order Types (out)

Regards,
Juergen

Thanks,

It was Conversion of Sales Order Types (out) the uncompleted data.

But I don´t understand why it´s necessary to fill in. There is no need to convert the order type.

The conversion table for order types is a special case.

Here you not only specifies the correct conversion of codes, but also determines which order types are processed through EDI.

You can refer to the Infor EDI documents (e.g. U7100B - EDI User Guide) where this is described in detail.

Regards,
Juergen

Can you provide me this document?. Documents I have dont´t explain this point.
At least I haven´t found it.

Thanks in AV

I have just send you a PM

HI,

Can you please share the same document with me...

Thanx..

Hi

will you please send me this document..
thanks in advance

helloakshay1@gmail.com

Hi,

Can you please send me U7100B user guide (Assuming this doc is for Ln 6.1).

Thanks.
ssharma@proinitiative.com.au

Cheers.

Hi,

are you sure that your general EDI setup is correct?

Check Sessions:
- Supported EDI Messages (Field "Active" is set to "yes" for ASN001)
- EDI Messages Supported by Business Partner
- Networks
- Business Partner EDI Data by Network
- Conversion of Sales Order Types (out)

Regards,
Juergen

Thanks you for the post.