May I know how do I populate/update Slow Moving field (a display field) in form 2 of Maintain Item Data session?

Appreciate some feedback. Thanks.

Hi,

you need to run the session tdinv6220m000 in Baan IV, in ERP LN 6 it is session whina6220m000. From the help on LN:
"A slow-moving analysis calculates the turnover rates, which are compared with the slow-moving percentage as specified in the Inventory Analysis Parameters (whina0100m000) session. This calculation results in a classification of items into ten categories in which the best category has the highest ratio of actual issue/inventory on hand."

I've ran the tdinv6220m000 session but it doesn't seem to update the Slow Moving field in the Maintain Item Data. Any idea why?

In Baan IV under Distribution Parameters go to maintain INV Parameters and on Form 3 enter the Slow-moving Analysis Parameters. Should be able to do Baan Help on the fields if you can't understand them. After you set these parameters then run the session tdinv6220m000 Perform Slow Moving Analysis by Item.

I've set the INV parameter as follow, for example:

turnover rate slow moving
10 100
20 90
30 80
.
.
.

and so forth, but still the Slow Moving field is not updated when i ran the Slow Moving Analysis session

Slow-Moving Analysis Parameters in my Company tdinv0100m000
To Turnover Rate Slow-Moving
(Upper Boundary) Percentage

0.10 75
0.50 50
1.00 25
2.00 10
99.99 0

ok, it works now...thanks a lot for your help!!!!!!!

Slow-Moving Analysis Parameters in my Company tdinv0100m000
To Turnover Rate Slow-Moving
(Upper Boundary) Percentage

0.10 75
0.50 50
1.00 25
2.00 10
99.99 0



mine is as below..

turnover rate slow moving
0.01 99
99.99 0


what is the different?

if i change to your what will happen?