A new blog entry has been added:

SFC Parameters asking for defaults and defaults asking for SFC parameters

When I am trying to setup the "series" for planning in the SFC parameters tisfc0100s000, the system is asking for SFC defaults tisfc0102m000, but when I am trying to create them then system is asking for SFC parameters.  This is like what is first the egg or the chicken??
This is in LN FP3
Do you know to fix this? is this an error or there is a procedure to fix this???  
 Thanks

Hello fertena,

are you sure the reason is the setup of the series for planning ? Sometimes the reason for such a behaviour is another entry (on another tab).

Try to change an other value in the parameters and save them. Did you get the same error message ?

If yes:
solve this problem first.

If no:
Create a record for the needed series in tisfc002 (SFC defaults) via GTM :-)
Afterwards you can modify both (paramters and defaults) without trouble.


Regards

Dieter